CPU Shutdown Sh
Posted: April 10th, 2013, 11:03 pm
I am trying to get my new server to run a shutdown script, but the sensors for the CPU do not display as "Core #" instead I have
Below is my sensor output
I am assuming f71889a-isa-0480 is my CPU (it's an AMD hexa core) and the three temp's are referencing three temp readings on the chip, so that's what I want to base this script on.
So I edited the script to read
Which when I run ./CPUTempShutdown.sh 30 5000 (trying a high number for testing this because i've accidently shut it down twice now, and dont feel like walking back to my box to shut it down...
For some reason when I run that, it's pulling temp 2 and 3 correct, but temp1 is pulling 15 from the first reading of temp1 in the sensor output... any suggestions here??? Although it seems to be the coolest reading so the other two should get higher first.. but if at all possible i would like all three to read properly..
Below is my sensor output
Code: Select all
k10temp-pci-00c3
Adapter: PCI adapter
temp1: +14.9°C (high = +70.0°C)
(crit = +80.0°C, hyst = +77.0°C)
fam15h_power-pci-00c4
Adapter: PCI adapter
power1: 32.89 W (crit = 94.99 W)
f71889a-isa-0480
Adapter: ISA adapter
+3.3V: +3.33 V
in1: +0.91 V (max = +2.04 V)
in2: +1.11 V
in3: +0.87 V
in4: +0.62 V
in5: +1.36 V
in6: +1.69 V
3VSB: +3.34 V
Vbat: +3.33 V
fan1: 3579 RPM
fan2: 778 RPM
fan3: 0 RPM ALARM
temp1: +27.0°C (high = +85.0°C, hyst = +81.0°C)
(crit = +80.0°C, hyst = +76.0°C) sensor = transistor
temp2: +35.0°C (high = +85.0°C, hyst = +79.0°C)
(crit = +109.0°C, hyst = +103.0°C) sensor = thermistor
temp3: +37.0°C (high = +70.0°C, hyst = +68.0°C)
(crit = +85.0°C, hyst = +83.0°C) sensor = transistor
nouveau-pci-0100
Adapter: PCI adapter
temp1: +60.0°C (high = +100.0°C, crit = +120.0°C)
I am assuming f71889a-isa-0480 is my CPU (it's an AMD hexa core) and the three temp's are referencing three temp readings on the chip, so that's what I want to base this script on.
So I edited the script to read
Code: Select all
str=$(sensors | grep "temp$i:")
newstr=${str:15:2}
Which when I run ./CPUTempShutdown.sh 30 5000 (trying a high number for testing this because i've accidently shut it down twice now, and dont feel like walking back to my box to shut it down...
For some reason when I run that, it's pulling temp 2 and 3 correct, but temp1 is pulling 15 from the first reading of temp1 in the sensor output... any suggestions here??? Although it seems to be the coolest reading so the other two should get higher first.. but if at all possible i would like all three to read properly..