Myth TV "grabber" problem

Post Reply
User avatar
kiniku70
Member
Member
Posts: 12
Joined: February 19th, 2015, 9:01 pm

Myth TV "grabber" problem

Post by kiniku70 »

I setup Myth TV then later added a HDHomerun extend tuner. Everything seems to be working fine. I am wanting U.S. broadcast TV only and I am subscribed to a lineup provider. The problem is when I run Mythweb I have channels listed but no lineup data is listed. When I run the mythfilldatabase refresh I receive this error: "No channels are configured to use grabber." I've gone up and down the settings and I cannot seem to find the cause of this error.

Any suggestions would be appreciated. Should I restart the entire Myth TV install and setup?
User avatar
kiniku70
Member
Member
Posts: 12
Joined: February 19th, 2015, 9:01 pm

Re: Myth TV "grabber" problem

Post by kiniku70 »

My problem was a lack of attention to detail. On Schedules Direct I didn't have a lineup selected. In my case OTA broadcast. So now refreshing mythfilldatabase ran noticeably slower.

That's what I get for setting up mythTV late at night under the influence :)
Post Reply